Fixed an issue for wrap toolpaths in which the wrap radius was not updated when choosing the cylinder and the operation could not be accepted.Added diagnostic information to the log when an adaptive toolpath fails to produce any result because the ramps are too large.Fixed an issue where the holder could collide with the remaining stock when rest machining and reduced air cutting were enabled.Fixed a potential crash in rest machining when a previous stock level with stock gets completely cleared at a later stage.Fixed an issue where rest machining for pocket clearing did not remove all accessible stock in some cases.Reduced the likelihood of pocket clearing toolpaths gouging when attempting to enter a slot of similar width to the tool diameter.Fixed several crashes that could occur in specific parts when using parallel or contour strategies.Fixed an issue where the adaptive clearing toolpath could crash or hang when the reduced air cutting feature flag was enabled.Fixed a potential stock collision due to missed machining levels which could occur in some cases of adaptive clearing.(#26891).This may increase in tool-wear as the entire pocket is included in the remaining stock in this operation." (#22621) The message is also updated to "Warning: A pocket, which was not machined by previous operations because they used tools that were too large, has now been fully machined in this operation. The warning message "Skipping a pocket since the rest tool has not removed any material" will now only show when a pocket was untouched by the rest tool, and the entire stock is left for the rest operation.
#Autodesk fusion 360 system requirements update#
The following changes were made in an earlier update (2022.2):
Installation WHAT’S NEW The following changes have been made in the current update (2022.2.1):
This document covers these Inventor CAM products: Autodesk® Inventor CAM™ 2022.2.1 Release Notes
0 kommentar(er)
